汽车塑料件用水性涂料工艺特点
时间:2021-7-15 14:52:12 作者:703660009 来源:汽车 阅读:712次
2017年10月28日-介绍了塑料件用水性涂料的技术参数和施工特点。比较 装件、内饰件和功能结构件。汽车车身常用外饰塑料 了
2009年4月14日-汽车塑料件用水性涂料工艺特点;摘要:汽车塑料件用水性涂料工艺特点,工艺,汽车,水性,塑料件,涂料-涂装设备涂装技术论坛-蓝天CAD论坛
2013年8月12日-汽车塑料件用水性涂料工艺特点第27 卷第10 期Vo1.27N0.10 了欧关系和日系3C1B塑料保险杠水性喷漆工艺.对比了塑料 中图分类号:TQ639.2文献标志码:A
摘 要:由于环保要求,汽车塑料件涂装正朝着水性化的方向
发展。介绍了塑料件用水性涂料的技术参数和施工特点。比较
了欧美系和日系 3C1B 塑料保险杠水性喷漆工艺。对比了塑料
件用水性涂料与溶剂型涂料的施工特点。讨论了塑料件静电喷
涂工艺以及影响涂装质量的因素。分析了目前国内汽车塑料件水
性涂料推广面临的问题,提出了解决措施。
关键词:汽车;塑料件;水性涂料;涂装;施工工艺
中图分类号:TQ639.2 文献标志码:A
文章编号:1004 – 227X (2008) 10 – 0044 – 04
Process characteristic of waterborne coatings used for
automobile plastic workpiece // ZHANG Guo-zhong, LI
Guo-bo
Abstract: The automobile plastic workpiece coating is
toward developing waterborne coatings because of
environment protection requirement. Technical parameters
and construction requirements for a waterborne coating used
for automobile plastic workpiece were introduced. The
differences between two coating processes of
Euro-American system and Japanese 3C1B system for
plastic bumper were compared. The construction
characteristics between waterborne coatings and solvent
coatings were compared. The electrostatic spraying process
of plastic workpiece and the factors effecting coating quality
were discussed. Problems existing in the popularization of
waterborne coatings for automobile plastic workpiece were
analyzed and their solutions presented.
Keywords: automobile; plastic workpiece; waterborne
coating; coating; construction process
First-author’s address: Chery712
下载说明:
1.请先分享,再下载
2.直接单击下载地址,不要使用“目标另存为”
3.压缩文件请先解压
4.PDF文件,请用PDF专用软件打开查看
5.如果资料不能下载,请联系本站